User Tools
phase1:phase1:runber
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| phase1:phase1:runber [2016/07/13 10:05] – leac | phase1:phase1:runber [2016/08/23 17:43] (current) – leac | ||
|---|---|---|---|
| Line 33: | Line 33: | ||
| * 1: Should be always on | * 1: Should be always on | ||
| - | * 2: Datatype. | + | * 2: Datatype. |
| * 3: Errortype. OFF: no automatic error detection, ON: 1 error/s. Use OFF setting | * 3: Errortype. OFF: no automatic error detection, ON: 1 error/s. Use OFF setting | ||
| Line 47: | Line 47: | ||
| * To run with random bit stream at 400Mbits: push SW6, SW8, SW7 | * To run with random bit stream at 400Mbits: push SW6, SW8, SW7 | ||
| * To run with random bit stream at 100Mbits: push SW6, SW5, SW7 | * To run with random bit stream at 100Mbits: push SW6, SW5, SW7 | ||
| + | |||
| + | === LEDs === | ||
| + | * DS7: Blinking green if FPGA ready | ||
| + | * DS6: Green light if no error detected, turns off if error detected | ||
phase1/phase1/runber.1468397153.txt.gz · Last modified: by leac
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
