STANDA passive vibration damping optical table
The entire setup is hosted on a STANDA passive vibration damping optical table. It consist of a hut, support and a filter unit. A complet visualisation is below:
The table support used in this setup uses is the: 1TS05-12-06-AR. DIfferent rubber support ellements are available the one used to hold the optical table are the support subber leveling element 1TS-AR the ones for on the ground are the Solid leveling element 1TS-AS. On top of the table support resides the 1HT08-20-20 (800 x 2000 x200mm) Optical Table Tops.
Aditionally a fan and two light switches are installed, to turn the fan and lights on/off separately. As light source the dai light lamp 1CB-WL is used
Filter Unit
On top of the unit is the HEPA filter unit. Filter specification:
- Three speed switch features low, medium, and high settings; standard on all 2 ft x 4 ft (600 mm x 1,210 mm) and 2 ft x 3.5 ft (600 mm x 1,057 mm) units.
- Solid-state speed control standard on 2 ft x 2 ft (600 mm x 600 mm) and 2 ft x 3 ft (600 mm x 905 mm) units.
- Forward-inclined centrifugal-type fan.
- High Efficiency Particulate Air (HEPA) UL 900 Filter: 99.99% efficient at 0.3 micron.
- Extremely Quiet <50 dBA
- Snap-in pre filter allows for easy replacement and maintenance.
- Mill finished aluminum exterior.
- Tested to IEST recommended RPC standards.
- UL listed (120V, 240V, 277V) with standard UL 900 filter.
The filter unit is produced by ENVIRCO corporation and consist of the MAC 10® Original Fan Filter Unit
