Differences

This shows you the differences between two versions of the page.

--- standa_low_vibration_optical_table [2024/12/11 13:32] – simon
+++ standa_low_vibration_optical_table [2025/02/04 11:28] (current) – [Filter Unit] simon
@@ Line 1: / Line 1: @@
-====== STANDA passive vibration dumpong optical table ======
+====== STANDA passive vibration damping optical table ======
 The entire setup is hosted on a STANDA passive vibration damping optical table. It consist of a hut, support and a filter unit. A complet visualisation is below:
-{{ :setup:standa:standa.png?400 |Entire table}}
 ----
-The table support used in this setup uses is the: 1TS05-12-06-AR. DIfferent rubber support ellements are available the one used to hold the optical table are the support subber leveling element 1TS-AR the ones for on the ground are the Solid leveling element 1TS-AS
+{{:setup:standa:standa.png?400 |}}
-{{:setup:standa:optical_table_supports.jpg?400|}}
+{{ :setup:standa:standamanuall.png?400|}}
 ----
+The table support used in this setup uses is the: 1TS05-12-06-AR. Different rubber support ellements are available the one used to hold the optical table are the support rubber leveling element 1TS-AR the ones for on the ground are the Solid leveling element 1TS-AS. On top of the table support resides the 1HT08-20-20 (800 x 2000 x200mm) Optical Table Tops.
+{{:setup:standa:optical_table_supports.jpg?400 |}}
+{{ :setup:standa:tablesupportmanual.png?400|Manual}}
+----
+Aditionally a fan and two light switches are installed, to turn the fan and lights on/off separately. As light source the day light lamp 1CB-WL is used
+===== Filter Unit =====
+On top of the unit is the HEPA filter unit, the one used has the model number: FF45A-A004. Filter specification:
+  * Three speed switch features low, medium, and high settings; standard on all 2 ft x 4 ft (600 mm x 1,210 mm) and 2 ft x 3.5 ft (600 mm x 1,057 mm) units.
+  * Solid-state speed control standard on 2 ft x 2 ft (600 mm x 600 mm) and 2 ft x 3 ft (600 mm x 905 mm) units.
+  * Forward-inclined centrifugal-type fan.
+  * High Efficiency Particulate Air (HEPA) UL 900 Filter (which is gel sealed): 99.99% efficient at 0.3 micron.
+  * Extremely Quiet <50 dBA
+  * Snap-in pre filter allows for easy replacement and maintenance.
+  * Mill finished aluminum exterior.
+  * Tested to IEST recommended RPC standards.
+  * UL listed (120V, 240V, 277V) with standard UL 900 filter.
+  * Size of the ULPA filter: 23,63 x 47,63 x 9,125 (width x length x high) inches
+The filter unit is produced by ENVIRCO corporation and consist of the MAC 10® Original Fan Filter Unit
+  * {{ :setup:standa:mac10xl.pdf |Datasheet of the MAC10XL filter unit}}
+  * {{ :setup:standa:mac10original_v67-21-05.pdf |MAC10 Installation and service manual}}
+  * {{ :setup:standa:filter-fan-unit-manual-envirco-mac-10-original.pdf |Installation manual}}
+  * {{ :setup:standa:265888-500_universal_control_card_2_iom_0217.pdf |Control card manual}}

Physik-Institut

Physik-Institut DAMIC Wiki

Differences

Physik-Institut

Physik-Institut DAMIC Wiki

User Tools

Site Tools

Differences

Page Tools