This is an old revision of the document!
RD53 @ UZH
Everything should be already good to go but just in case
Kintex firmware installation
Connect the KC705 with the computer through JTAG connector.
Open Vivado and Go Open Hardware Manager→ Open Target→ Auto connect
now the KC705 should appear if it is properly connected.
Right click on the card and go to add configuration memory and follow the steps indicated in the
bdaq53 twiki to program using flash memory (I recommend this method because even if you turn off the FPGA permanently programmed) .
https://gitlab.cern.ch/silab/bdaq53/
and
https://gitlab.cern.ch/sifca/bdaq53
bdaq53 installation
conda install numpy bitarray pyyaml scipy numba pytables matplotlib tqdm pyzmq blosc psutil
pip install git+https://gitlab.cern.ch/silab/bdaq53.git@master