This is an old revision of the document!
To Do List
Power
Full chain test
Check change in current as a function of module Vana setting
Check functionality of RDA passing for CB L3 and L4 (currently not possible due to broken L4 connector)
Implement procedure for full chain test including all tests we did so far: CCU redundancy, i2c programming, DOH/PLL setting, Delay25 scan for SDA, Delay25 scan for RDA, …
Check LV and HV distribution
Check that reset does not trigger cross-talk
Digital FED
Optical signals
Repeat optical performance measurements using analog FED
Repeat ADC calibration using scope
Perform measurements at cold
Mechanical
Hardware
make adapter prints for modules
make board to check power distribution
make board to inject signals simultaneously
Software