phase1:phase1:runber
This is an old revision of the document!
How to run BER test
- Connect UZH L3 Testboard with LVDS input signal connected
- Connect a POH with fiber 2 connected to L3 position
- Connect Dani's BER board:
CON880A: Data OUT: Ethernet cable going to UZH L3 Testboard CON500C: Data IN: Ethernet cable coming from FED
- Turn on CCU and opto power
- Configure POH. Login to cmspixel2:
cd TriDAS/pixel/BPixelTools/ccu ./run.bsh > reset > piareset all > scanccu > i2c 0x13 0x1a 10 > i2c 0x13 0x1b 0
- Initialize digital FED 0x4C000000. Login to cmspixel:
cd TriDAS/pixel/BPixelTools/initfed ./run.bsh > initFitelN * Connect Dani's BER board: CON880A: Data OUT, CON500C: Data IN * Data OUT: Ethernet cable going to UZH L3 Testboard * Data IN: Ethernet cable coming from FED
phase1/phase1/runber.1468396490.txt.gz · Last modified: 2016/07/13 09:54 by leac
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
