This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
phase1:phase1:runber [2016/07/13 10:02] – leac | phase1:phase1:runber [2016/08/23 17:43] (current) – leac | ||
---|---|---|---|
Line 33: | Line 33: | ||
* 1: Should be always on | * 1: Should be always on | ||
- | * 2: Datatype. | + | * 2: Datatype. |
* 3: Errortype. OFF: no automatic error detection, ON: 1 error/s. Use OFF setting | * 3: Errortype. OFF: no automatic error detection, ON: 1 error/s. Use OFF setting | ||
+ | |||
+ | === Buttons === | ||
+ | |||
+ | * SW6: Reset FPGA | ||
+ | * SW7: Reset error counter | ||
+ | * SW5: Set Synch | ||
+ | * SW8: Set Sequence | ||
+ | * SW4: Introduce bit error | ||
+ | |||
+ | * To run with idle pattern: push SW6, SW7 | ||
+ | * To run with random bit stream at 400Mbits: push SW6, SW8, SW7 | ||
+ | * To run with random bit stream at 100Mbits: push SW6, SW5, SW7 | ||
+ | |||
+ | === LEDs === | ||
+ | * DS7: Blinking green if FPGA ready | ||
+ | * DS6: Green light if no error detected, turns off if error detected |