phase1:phase1:pos
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| phase1:phase1:pos [2016/09/13 12:03] – ngadiuba | phase1:phase1:pos [2016/09/14 11:25] (current) – ngadiuba | ||
|---|---|---|---|
| Line 121: | Line 121: | ||
| lowvoltagemap | lowvoltagemap | ||
| - | 5) edit the calib.dat file with the input parameters of the new calibration (ex: what to scan, scan range, etc..). For the example above the file should stay under config/ | + | 5) edit the calib.dat file with the input parameters of the new calibration (ex: what to scan, scan range, etc..). For the example above the file should stay under **config/ |
| | | ||
| - | ===== Run full calibration chain (to be finished) | + | ===== Calibration sequence |
| + | |||
| + | * The calibration sequence is described in [[https:// | ||
| + | |||
| + | * The calibrations parameters can be found in the corresponding calib.dat file in the config/ | ||
| + | |||
| + | * A detector configuration for switch 0 and switch 1 of the fitel receiver to use for testing calibrations can be found in [[https:// | ||
phase1/phase1/pos.1473761009.txt.gz · Last modified: 2016/09/13 12:03 by ngadiuba
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
