This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
phase1:phase1:mtcafull [2016/07/12 14:38] – [Hardware configuration] leac | phase1:phase1:mtcafull [2017/02/15 15:36] (current) – [Hardware configuration] leac | ||
---|---|---|---|
Line 2: | Line 2: | ||
==== Hardware configuration ==== | ==== Hardware configuration ==== | ||
- | + | TKFEC 0, ring 0x0, CCU 0x7c | |
- | | + | |
- | | + | |
- | | + | |
Line 31: | Line 31: | ||
| | ||
==== Configure AMC13 ==== | ==== Configure AMC13 ==== | ||
- | cd FEDTools | + | cd FEDtool |
amc13test settings/ | amc13test settings/ | ||
| | ||
==== Initialize ST electronics ==== | ==== Initialize ST electronics ==== | ||
- | cd FEDTools | + | cd TriDAS/ |
- | | + | |
+ | > reset | ||
+ | > piareset all | ||
+ | > scanccu | ||
+ | > ccu 0x7c | ||
+ | > channel 0x11 | ||
+ | > delay25 init | ||
+ | > delay25 set d0 0 | ||
+ | > delay25 set d1 39 | ||
+ | > delay25 set d2 10 | ||
+ | > delay25 set d3 0 | ||
+ | > pll reset | ||
+ | > pll init | ||
+ | > doh init | ||
+ | > i2c 0x11 0x8 30 | ||
+ | > i2c 0x11 0xb 63 | ||
+ | |||
+ | The commands above are also implemented in a script: | ||
+ | cd TriDAS/ | ||
+ | python init.py | ||
+ | |||
+ | |||
+ | ==== Initialize the module ==== | ||
+ | |||
+ | cd TriDAS/ | ||
+ | ./run.bsh | ||
+ | > exec data/ | ||
+ | |||
+ |