cluster:lhcb
This is an old revision of the document!
Table of Contents
LHCb Software
LHCb software can be accessed in three different ways:
- over CernVM-FS
⇒ default setting - over AFS
⇒ needed for special settings, e.g. debug sessions - over local disk /disk/slc5/sw
⇒ not maintained anymore
CernVM-FS
SLC5 Cluster
The software environment is identical to CERN. Nothing addtional has to be done to use LHCb software.
Setup your project:
SetupProject PROJECT VERSION
openSUSE Cluster 64bit
Install LHCb environment:
- KSH type shell:
. /disk/lhcb/sw-slc5/scripts/lhcb_setup.sh
- CSH type shell:
source /disk/lhcb/sw-slc5/scripts/lhcb_setup.csh
Setup your project:
SetupProject PROJECT VERSION
AFS
SLC5 Cluster
openSUSE Cluster 64bit
Set the architecture:
- KSH type shell:
export CMTCONFIG=x86_64-slc5-gcc43-opt
- CSH type shell:
setenv CMTCONFIG x86_64-slc5-gcc43-opt
Local Disk
Installed Software
Local installed LHCb software on /disk/slc5/sw
SLC5 Cluster
Install LHCb environment:
- KSH type shell:
. /disk/lhcb/sw-slc5/scripts/lhcb_setup.sh
- CSH type shell:
source /disk/lhcb/sw-slc5/scripts/lhcb_setup.csh
Setup your project:
SetupProject PROJECT VERSION
openSUSE Cluster 64bit
Install LHCb environment:
- KSH type shell:
. /disk/lhcb/sw-slc5/scripts/lhcb_setup.sh
- CSH type shell:
source /disk/lhcb/sw-slc5/scripts/lhcb_setup.csh
Setup your project:
SetupProject PROJECT VERSION
cluster/lhcb.1321280950.txt.gz · Last modified: 2011/11/14 15:29 by bernet
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
