This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
cluster:lhcb [2020/08/27 10:15] – bernet | cluster:lhcb [2021/11/04 12:48] (current) – bernet | ||
---|---|---|---|
Line 3: | Line 3: | ||
LHCb software can be accessed in three different ways: | LHCb software can be accessed in three different ways: | ||
* over CernVM-FS\\ => default setting | * over CernVM-FS\\ => default setting | ||
- | * over AFS\\ => needed for special settings, e.g. debug sessions | + | * over AFS\\ => needed for special settings, e.g. debug sessions\\ => not maintained anymore |
* over local disk / | * over local disk / | ||
Line 12: | Line 12: | ||
The software environment is identical to CERN. Nothing addtional has to be done to use LHCb software.\\ \\ | The software environment is identical to CERN. Nothing addtional has to be done to use LHCb software.\\ \\ | ||
Set runtime environment:< | Set runtime environment:< | ||
+ | |||
+ | == openSUSE Cluster 64bit == | ||
+ | Install LHCb environment: | ||
+ | * KSH type shell:< | ||
+ | * CSH type shell:< | ||
+ | |||
+ | Set runtime environment:< | ||
+ | |||
+ | |||
+ | ==== Obsolate Operating Systems ==== | ||
== SLC6 Cluster == | == SLC6 Cluster == | ||
Line 20: | Line 30: | ||
The software environment is identical to CERN. Nothing addtional has to be done to use LHCb software.\\ \\ | The software environment is identical to CERN. Nothing addtional has to be done to use LHCb software.\\ \\ | ||
Setup your project:< | Setup your project:< | ||
- | |||
- | == openSUSE Cluster 64bit == | ||
- | Install LHCb environment: | ||
- | * KSH type shell:< | ||
- | * CSH type shell:< | ||
- | |||
- | Setup your project:< | ||
==== AFS ==== | ==== AFS ==== | ||
+ | |||
+ | ( not maintained anymore ) | ||
== SLC6 Cluster == | == SLC6 Cluster == |