====== STANDA passive vibration damping optical table ======

The entire setup is hosted on a STANDA passive vibration damping optical table. It consist of a hut, support and a filter unit. A complet visualisation is below:
{{:setup:standa:standa.png?400 |}}
{{ :setup:standa:standamanuall.png?400|}}

----

The table support used in this setup uses is the: 1TS05-12-06-AR. DIfferent rubber support ellements are available the one used to hold the optical table are the support subber leveling element 1TS-AR the ones for on the ground are the Solid leveling element 1TS-AS. On top of the table support resides the 1HT08-20-20 (800 x 2000 x200mm) Optical Table Tops.
{{:setup:standa:optical_table_supports.jpg?400 |}}
{{ :setup:standa:tablesupportmanual.png?400|Manual}}

----
Aditionally a fan and two light switches are installed, to turn the fan and lights on/off separately. As light source the dai light lamp 1CB-WL is used
===== Filter Unit =====

On top of the unit is the HEPA filter unit. Filter specification:
  * Three speed switch features low, medium, and high settings; standard on all 2 ft x 4 ft (600 mm x 1,210 mm) and 2 ft x 3.5 ft (600 mm x 1,057 mm) units.
  * Solid-state speed control standard on 2 ft x 2 ft (600 mm x 600 mm) and 2 ft x 3 ft (600 mm x 905 mm) units.
  * Forward-inclined centrifugal-type fan.
  * High Efficiency Particulate Air (HEPA) UL 900 Filter: 99.99% efficient at 0.3 micron.
  * Extremely Quiet <50 dBA
  * Snap-in pre filter allows for easy replacement and maintenance.
  * Mill finished aluminum exterior.
  * Tested to IEST recommended RPC standards.
  * UL listed (120V, 240V, 277V) with standard UL 900 filter.

The filter unit is produced by ENVIRCO corporation and consist of the MAC 10® Original Fan Filter Unit
  * {{ :setup:standa:mac10xl.pdf |Datasheet of the MAC10XL filter unit}}
  * {{ :setup:standa:mac10original_v67-21-05.pdf |MAC10 Original filter unit manual}}
  * {{ :setup:standa:mac10xl.pdf |MAC10XL filter unit manual}}
  * {{ :setup:standa:265888-500_universal_control_card_2_iom_0217.pdf |Control card manual}}