This shows you the differences between two versions of the page.
Next revision | Previous revisionLast revisionBoth sides next revision | ||
users:rdelburgo [2018/10/04 11:01] – created delburgo | users:rdelburgo [2018/10/05 11:54] – [bdaq53 installation] delburgo | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== RD53 @ UZH ====== | ====== RD53 @ UZH ====== | ||
Everything should be already good to go but just in case | Everything should be already good to go but just in case | ||
+ | ====== Connecting the Kintex to the computer ====== | ||
+ | Is possible to communicate with the Kintex FPGA using a ethernet connector. | ||
+ | The ethernet connector has to be plugged directly in the computer ethernet bus, without using an external hub. | ||
+ | By default the board address is 192.168.10.16. | ||
+ | To be able to communicate create a network with the following settings: | ||
+ | |||
+ | IP Address: 192.168.10.10 | ||
+ | | ||
+ | | ||
+ | In UBUNTU you have to define this network in the file | ||
+ | / | ||
+ | And you can add it (if it is not already there) as | ||
+ | # The primary network interface | ||
+ | auto eth0 | ||
+ | iface eth0 inet static | ||
+ | address 192.168.10.10 | ||
+ | netmask 255.255.255.0 | ||
+ | gateway 0.0.0.0 | ||
+ | After that use the command | ||
+ | ifdown eth0; ifup eth0 | ||
+ | And check if the board is there: | ||
+ | ping 192.168.10.16 | ||
+ | |||
+ | |||
+ | ====== Kintex firmware installation ====== | ||
+ | Get the right firmware here **[[https:// | ||
+ | If not already installed, install the **[[https:// | ||
+ | |||
+ | * Connect the KC705 with the computer through JTAG connector. | ||
+ | * Open Vivado and Go Open Hardware Manager-> | ||
+ | * now the KC705 should appear if it is properly connected. | ||
+ | * Right click on the card and go to add configuration memory and follow the steps indicated in the **[[ https:// | ||
====== bdaq53 installation ====== | ====== bdaq53 installation ====== | ||
+ | * Install **[[https:// | ||
+ | * Install dependencies and bdaq53: | ||
+ | |||
+ | conda install numpy bitarray pyyaml scipy numba pytables matplotlib tqdm pyzmq blosc psutil | ||
+ | pip install git+https:// | ||
+ | |||
+ | * RD53A twiki: | ||
+ | |||
+ | ====== Run a test (work in progress)====== | ||
+ | **powering procedure missing on purpose, ask to someone who had already done it** | ||
- | * RD53A: | + | cd bdaq53/ |
- | * SCC: https:// | + | source setup.py develop |
- | * SCC schematic: https:// | + | |
- | | + | choose a test (for example scan_digital) and |
+ | bdaq53 |