This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
users:rdelburgo [2018/10/04 11:05] – [bdaq53 installation] delburgo | users:rdelburgo [2018/10/04 11:14] – [Kintex firmware installation] delburgo | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== RD53 @ UZH ====== | ====== RD53 @ UZH ====== | ||
Everything should be already good to go but just in case | Everything should be already good to go but just in case | ||
+ | ====== Connecting the Kintex to the computer ====== | ||
+ | |||
+ | ====== Kintex firmware installation ====== | ||
+ | |||
+ | * Connect the KC705 with the computer through JTAG connector. | ||
+ | * Open Vivado and Go Open Hardware Manager-> | ||
+ | * now the KC705 should appear if it is properly connected. | ||
+ | * Right click on the card and go to add configuration memory and follow the steps indicated in the **[[ https:// | ||
+ | |||
====== bdaq53 installation ====== | ====== bdaq53 installation ====== | ||
- | * Install [https:// | + | * Install |
* Install dependencies and bdaq53: | * Install dependencies and bdaq53: | ||
- | conda install numpy bitarray pyyaml scipy numba pytables matplotlib tqdm pyzmq blosc psutil | + | |
- | pip install git+https:// | + | pip install git+https:// |
* RD53A twiki: | * RD53A twiki: | ||
+ | |||
| |