Differences

This shows you the differences between two versions of the page.

--- users:ngadiuba:bpix:controlroom [2014/12/11 14:17] – ngadiuba
+++ users:ngadiuba:bpix:controlroom [2014/12/11 14:20] (current) – ngadiuba
@@ Line 85: / Line 85: @@
 ) Connect cooling tubes, power cables,  fibres.
 ) Switch on cooling, observe flow and pressure.
@@ Line 90: / Line 91: @@
 ) Select the right detconfig in the detconfig directory.
 ) Power CCU (2.5V), observe current.
 ) Power opto (2.5V)  sector by sector 1-8, observe currents.
 ) Run the test program to scan the rings. All devices should there.
 ) Loop over sectors
 Power LV (2.8 D, 1.99 A, power HV 150V).
 Configure, observe currents.
 ) Once all sector are up try baseline.
 ) If ROCs not programmed run DELAY25.
@@ Line 109: / Line 116: @@
 ) Delay 25
 ) Baseline
 ) Clock
 ) Baseline
 ) AohBias & AohGain
 ) Baseline
 ) ROCUB
 ) TBMUB
 ) Baseline
-) Address levels (this is the first time we will use hits
-                               so CalDel and VcThr are an issue)
+) Address levels (this is the first time we will use hits so CalDel and VcThr are an issue)
 If this works, be happy, if not do
 ) VcTheCalDelFIFO3 "toronado"
-      if it does not work try VcThrCalDelFIFO1
+if it does not work try VcThrCalDelFIFO1
- Than run again Address levels.
+Than run again Address levels.
 Now we can test the finer cleanness.
 Final calibrations at the final temperature.

CMS Wiki Pages