This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
users:ngadiuba:bpix:controlroom [2014/12/11 14:05] – ngadiuba | users:ngadiuba:bpix:controlroom [2014/12/11 14:20] (current) – ngadiuba | ||
---|---|---|---|
Line 85: | Line 85: | ||
1) Connect cooling tubes, power cables, | 1) Connect cooling tubes, power cables, | ||
+ | |||
2) Switch on cooling, observe flow and pressure. | 2) Switch on cooling, observe flow and pressure. | ||
For each shell, start e.g. with BpI | For each shell, start e.g. with BpI | ||
- | + | ||
3) Select the right detconfig in the detconfig directory. | 3) Select the right detconfig in the detconfig directory. | ||
+ | |||
4) Power CCU (2.5V), observe current. | 4) Power CCU (2.5V), observe current. | ||
- | 5) Power opto (2.5V) | + | |
- | | + | 5) Power opto (2.5V) |
- | 6) Run the test program to scan the rings. | + | |
- | | + | 6) Run the test program to scan the rings. All devices should there. |
7) Loop over sectors | 7) Loop over sectors | ||
- | | + | Power LV (2.8 D, 1.99 A, power HV 150V). |
- | Configure, observe currents. | + | Configure, observe currents. |
8) Once all sector are up try baseline. | 8) Once all sector are up try baseline. | ||
+ | |||
9) If ROCs not programmed run DELAY25. | 9) If ROCs not programmed run DELAY25. | ||
Line 111: | Line 116: | ||
1) Delay 25 | 1) Delay 25 | ||
+ | |||
2) Baseline | 2) Baseline | ||
+ | |||
3) Clock | 3) Clock | ||
+ | |||
4) Baseline | 4) Baseline | ||
+ | |||
5) AohBias & AohGain | 5) AohBias & AohGain | ||
+ | |||
6) Baseline | 6) Baseline | ||
+ | |||
7) ROCUB | 7) ROCUB | ||
+ | |||
8) TBMUB | 8) TBMUB | ||
+ | |||
9) Baseline | 9) Baseline | ||
- | 10) Address levels (this is the first time we will use hits | + | |
- | so CalDel and VcThr are an issue) | + | 10) Address levels (this is the first time we will use hits so CalDel and VcThr are an issue) |
If this works, be happy, if not do | If this works, be happy, if not do | ||
11) VcTheCalDelFIFO3 " | 11) VcTheCalDelFIFO3 " | ||
- | | + | if it does not work try VcThrCalDelFIFO1 |
- | Than run again Address levels. | + | Than run again Address levels. |
Now we can test the finer cleanness. | Now we can test the finer cleanness. | ||
Final calibrations at the final temperature. | Final calibrations at the final temperature. |