phase1:phase1
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
| phase1:phase1 [2018/06/08 18:32] – leac | phase1:phase1 [2019/01/25 11:32] – [Mapping] leac | ||
|---|---|---|---|
| Line 89: | Line 89: | ||
| * FED channel mapping for FITEL receiver: http:// | * FED channel mapping for FITEL receiver: http:// | ||
| * HV mapping: http:// | * HV mapping: http:// | ||
| + | * Power cables: http:// | ||
| + | * Temperature sensors: http:// | ||
| + | * BPIX hub id: http:// | ||
| + | * Cooling -z: http:// | ||
| + | * Cooling +z: http:// | ||
| ====== Manuals ====== | ====== Manuals ====== | ||
| Counting room: | Counting room: | ||
| Line 114: | Line 119: | ||
| * TBM08b: http:// | * TBM08b: http:// | ||
| * TBM09: | * TBM09: | ||
| + | * Module configuration: | ||
| * Module testing reference guide: https:// | * Module testing reference guide: https:// | ||
| DTB: | DTB: | ||
| Line 160: | Line 166: | ||
| * UZH Adapterboard L2-L1: http:// | * UZH Adapterboard L2-L1: http:// | ||
| * UZH Adapterboard 2L2-L1: http:// | * UZH Adapterboard 2L2-L1: http:// | ||
| + | |||
| + | * HMX carrier board: http:// | ||
| | | ||
| + | * Pinout of MSC connector: http:// | ||
| + | * Pinout of AUX connector: http:// | ||
| + | * D4603 backboard: http:// | ||
| * Pinout of DTB connector: http:// | * Pinout of DTB connector: http:// | ||
phase1/phase1.txt · Last modified: 2019/02/05 10:46 by leac
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
