User Tools
phase1:phase1:runber
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| phase1:phase1:runber [2016/07/13 09:54] – leac | phase1:phase1:runber [2016/07/13 10:02] – leac | ||
|---|---|---|---|
| Line 6: | Line 6: | ||
| CON880A: Data OUT: Ethernet cable going to UZH L3 Testboard | CON880A: Data OUT: Ethernet cable going to UZH L3 Testboard | ||
| - | CON500C: Data IN: Ethernet cable coming from FED | + | CON500C: Data IN: Ethernet cable coming from FED |
| * Turn on CCU and opto power | * Turn on CCU and opto power | ||
| Line 25: | Line 25: | ||
| > initFitelN | > initFitelN | ||
| | | ||
| - | * Connect Dani's BER board: CON880A: | + | === Probing |
| - | * Data OUT: Ethernet cable going to UZH L3 Testboard | + | |
| - | * Data IN: Ethernet cable coming from FED | + | |
| + | * CON 805/806: Differential signal OUT | ||
| + | * Differntial signal IN: Right two resistors next to CON500C | ||
| + | |||
| + | === Settings on Switch S2 === | ||
| + | |||
| + | * 1: Should be always on | ||
| + | * 2: Datatype. ON: fixed pattern, OFF: PRBS | ||
| + | * 3: Errortype. OFF: no automatic error detection, ON: 1 error/s. Use OFF setting | ||
phase1/phase1/runber.txt · Last modified: by leac
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
