This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
phase1:phase1:runber [2016/07/13 09:53] – leac | phase1:phase1:runber [2016/07/13 10:02] – leac | ||
---|---|---|---|
Line 3: | Line 3: | ||
* Connect UZH L3 Testboard with LVDS input signal connected | * Connect UZH L3 Testboard with LVDS input signal connected | ||
* Connect a POH with fiber 2 connected to L3 position | * Connect a POH with fiber 2 connected to L3 position | ||
- | * Connect Dani's BER board: | + | * Connect Dani's BER board: |
- | Data OUT: Ethernet cable going to UZH L3 Testboard | + | |
- | Data IN: Ethernet cable coming from FED | + | |
- | * Connect UZH L3 Testboard with LVDS input signal connected | ||
- | * Connect a POH with fiber 2 connected to L3 position | ||
- | * Connect Dani's BER board: CON880A: Data OUT, CON500C: Data IN | ||
- | | ||
- | | ||
* Turn on CCU and opto power | * Turn on CCU and opto power | ||
* Configure POH. Login to cmspixel2: | * Configure POH. Login to cmspixel2: | ||
Line 30: | Line 25: | ||
> initFitelN | > initFitelN | ||
| | ||
- | * Connect Dani's BER board: CON880A: | + | === Probing |
- | * Data OUT: Ethernet cable going to UZH L3 Testboard | + | |
- | * Data IN: Ethernet cable coming from FED | + | * CON 805/806: Differential signal |
+ | * Differntial signal | ||
+ | |||
+ | === Settings on Switch S2 === | ||
+ | * 1: Should be always on | ||
+ | * 2: Datatype. ON: fixed pattern, OFF: PRBS | ||
+ | * 3: Errortype. OFF: no automatic error detection, ON: 1 error/s. Use OFF setting |