This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
phase1:phase1:runber [2016/07/13 09:53] – leac | phase1:phase1:runber [2016/07/13 09:58] – leac | ||
---|---|---|---|
Line 3: | Line 3: | ||
* Connect UZH L3 Testboard with LVDS input signal connected | * Connect UZH L3 Testboard with LVDS input signal connected | ||
* Connect a POH with fiber 2 connected to L3 position | * Connect a POH with fiber 2 connected to L3 position | ||
- | * Connect Dani's BER board: | + | * Connect Dani's BER board: |
- | Data OUT: Ethernet cable going to UZH L3 Testboard | + | |
- | Data IN: Ethernet cable coming from FED | + | |
- | * Connect UZH L3 Testboard with LVDS input signal connected | ||
- | * Connect a POH with fiber 2 connected to L3 position | ||
- | * Connect Dani's BER board: CON880A: Data OUT, CON500C: Data IN | ||
- | | ||
- | | ||
* Turn on CCU and opto power | * Turn on CCU and opto power | ||
* Configure POH. Login to cmspixel2: | * Configure POH. Login to cmspixel2: | ||
Line 30: | Line 25: | ||
> initFitelN | > initFitelN | ||
| | ||
- | * Connect Dani's BER board: CON880A: Data OUT, CON500C: Data IN | + | === Inject signals |
- | * Data OUT: Ethernet cable going to UZH L3 Testboard | + | |
- | * Data IN: Ethernet cable coming | + |