This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
phase1:phase1:pos [2016/09/13 10:34] – ngadiuba | phase1:phase1:pos [2016/09/14 11:25] (current) – ngadiuba | ||
---|---|---|---|
Line 88: | Line 88: | ||
2) create your calibration classes: PixelMyCalibration and PixelFEDMyCalibration (follow for instance PixelTBMDelayCalibration and PixelFEDTBMDelayCalibration classes) | 2) create your calibration classes: PixelMyCalibration and PixelFEDMyCalibration (follow for instance PixelTBMDelayCalibration and PixelFEDTBMDelayCalibration classes) | ||
- | 3) add the new calibration to the file config/ | + | 3) add the new calibration to the file **config/ |
- | + | ||
- | ===== Run full calibration chain (to be finished) | + | ... |
+ | Gain99By3 | ||
+ | GainBy3 | ||
+ | Iana 21 ; | ||
+ | ROCDelay | ||
+ | ReadbackCalibration 23 ; | ||
+ | Vdig 24 ; | ||
+ | MyCalibration 25 ; | ||
+ | |||
+ | 4) add the calibration key to the file **config/ | ||
+ | |||
+ | ... | ||
+ | key 25 | ||
+ | detconfig | ||
+ | nametranslation | ||
+ | fedconfig | ||
+ | fecconfig | ||
+ | fedcard | ||
+ | dac 0 | ||
+ | maxvsf | ||
+ | mask 0 | ||
+ | trim 0 | ||
+ | calib 25 | ||
+ | tbm 0 | ||
+ | portcard | ||
+ | portcardmap | ||
+ | ttcciconfig | ||
+ | ltcconfig | ||
+ | tkfecconfig | ||
+ | lowvoltagemap | ||
+ | |||
+ | 5) edit the calib.dat file with the input parameters of the new calibration (ex: what to scan, scan range, etc..). For the example above the file should stay under **config/ | ||
+ | |||
+ | |||
+ | | ||
+ | ===== Calibration sequence | ||
+ | |||
+ | * The calibration sequence is described in [[https:// | ||
+ | |||
+ | * The calibrations parameters can be found in the corresponding calib.dat file in the config/ | ||
+ | |||
+ | * A detector configuration for switch 0 and switch 1 of the fitel receiver to use for testing calibrations can be found in [[https:// |