This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
phase1:phase1:pos [2016/09/13 12:00] – ngadiuba | phase1:phase1:pos [2016/09/14 11:24] – ngadiuba | ||
---|---|---|---|
Line 120: | Line 120: | ||
tkfecconfig | tkfecconfig | ||
lowvoltagemap | lowvoltagemap | ||
- | + | ||
- | ===== Run full calibration chain (to be finished) | + | 5) edit the calib.dat file with the input parameters of the new calibration (ex: what to scan, scan range, etc..). For the example above the file should stay under **config/ |
+ | |||
+ | |||
+ | | ||
+ | ===== Calibration sequence | ||
+ | |||
+ | The calibration sequence is described in [[https:// | ||
+ | |||
+ | The calibrations parameters can be found in the corresponding calib.dat file in the config/ | ||
+ | |||
+ | A detector configuration for switch 0 and switch 1 of the fitted receiver to use for testing calibrations can be found in [[https:// |