User Tools
phase1:phase1:modulereadout
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| phase1:phase1:modulereadout [2015/11/20 13:27] – leac | phase1:phase1:modulereadout [2015/11/20 13:31] (current) – leac | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Module Readout ====== | ====== Module Readout ====== | ||
| + | |||
| + | ====Setup==== | ||
| + | Turn on crate\\ | ||
| + | Turn on CAEN PS\\ | ||
| + | Login to cmspixel PC\\ | ||
| + | Start " | ||
| + | |||
| + | ====Configure i2c devices==== | ||
| + | Initialize all devices\\ | ||
| + | cd TriDAS/ | ||
| + | python init.py | ||
| + | | ||
| + | ====Configure module==== | ||
| + | In pxfec process:\\ | ||
| + | exec data/d.ini | ||
| + | |||
| + | ====Trigger==== | ||
| + | Start XDAQ TTC control:\\ | ||
| + | source TriDAS/ | ||
| + | cd run/TTC/ | ||
| + | source run_ttcci.csh | ||
| + | |||
| + | Open firefox (" | ||
| + | In the TTCciControl tab: | ||
| + | click: configure | ||
| + | click: enable | ||
| + | Go to CyclicGen tab: | ||
| + | send repetitive triggers with desired rate | ||
| + | |||
| + | Check module readout data on scope by looking at the optical fiber of the POH. | ||
phase1/phase1/modulereadout.1448022430.txt.gz · Last modified: by leac
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
