This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
phase1:phase1:bpixeltools [2015/03/27 17:20] – ngadiuba | phase1:phase1:bpixeltools [2015/05/21 11:38] (current) – ngadiuba | ||
---|---|---|---|
Line 13: | Line 13: | ||
help // to get a list of options when using the command line interface | help // to get a list of options when using the command line interface | ||
- | Main general commands: | + | Some general commands: |
+ | * **scanccu** : returned the list of the connected CCUs | ||
* **scanringedevice** : scan all the connected electronic devices and addresses (ccu, dohs, pohs, ... ) | * **scanringedevice** : scan all the connected electronic devices and addresses (ccu, dohs, pohs, ... ) | ||
* **scanpixeldevice** : summary of the connected and missing devices (no addresses list) | * **scanpixeldevice** : summary of the connected and missing devices (no addresses list) | ||
+ | * **delay25 init** , **pll init** , **doh init** : initialize the devices | ||
To check pohN response (N = 1, | To check pohN response (N = 1, | ||
Line 24: | Line 26: | ||
* **pohN read** : read the values of the 4 channels bias and gain (b0, b1, b2, b3, g0, g1, g2, g3) | * **pohN read** : read the values of the 4 channels bias and gain (b0, b1, b2, b3, g0, g1, g2, g3) | ||
* to set the bias or the gain do for example: **pohN set b0 30** | * to set the bias or the gain do for example: **pohN set b0 30** | ||
- | * to set all the values at the same time do for example: **pohN set all 3 3 3 3 0 0 0 0** | + | * to set all the values at the same time do for example: **pohN set all 3 3 3 3 0 0 0 0** |
+ | * to init the poh settings: **pohN init** | ||
- | To check i2c speed: | + | To test i2c speed: |
* first set the ccu: **ccu 0x7b** | * first set the ccu: **ccu 0x7b** | ||
Line 78: | Line 81: | ||
====pxFEC==== | ====pxFEC==== | ||
+ | |||
Start the server: | Start the server: | ||
+ | |||
cd TriDAS/ | cd TriDAS/ | ||
| | ||
| | ||
+ | |||
+ | Some commands: | ||
+ | |||
+ | * **exec data/ | ||
+ | * **cn +2PL12** : set control network (+2PL12 for layers 1-2 and +2PL3 for layers 3-4) | ||
+ | * **module 31** : set the module hub | ||
+ | * **roc 0:15** : set the ROCs you want to program | ||
+ | * **Vana 120** : program the ROCs registers (ex: Vana) | ||
+ | * **tbm reset** : reset the tbm | ||
+ | * **tbm disable triggers** (**tbm enable triggers**) : force no token passed mode (the tbm does not wait for the token to be returned) | ||
+ | * **tbm enablepkam** (**tbm disablepkam**) : the tbm is reset after a lapse of time in which it does not receive the token back |